Lusithand Double NFP Special MKII
The ‘Double NFP-Special MKII’ preamp is specifically designed for Multi-coil pickups that feature a “one humbucker per string” coil wiring, simulating Wal MK electronics. The idea is to get a full Humbucker pickup with one pair of coils per string combining them electronically for minimum loading effect and string isolation. This method of mixing the coils brings maximum output, clarity, and punch out of the pickups without any adverse loading effects.
The filter controls have sweepable resonant peaks that ranges from 100hz to 2.5 kHz, on the Neck, and 200Hz to 2.5kHz on the Bridge. You can also boost the cut-off frequency(resonant peak) by pulling up the potentiometer.
The new ‘Double NFP-Special MKII’ filter preamp features a new Treble boost, labelled ‘Attack’, accessible via a push-pull switch on the Volume potentiometer. This allows to add a narrow set of Treble frequencies to the signal.
To use with multi-coil pickups (1 humbucker per string coil configuration), the Double NFP-Special has dedicated inputs to accommodate this type of pickup and together, they closely simulate Wal MK electronics.
It offers 6x inputs so that you can wire any multi-coil pickup up to 6 strings.
Check Turner Pickups to find your match.
!!No active/passive switching or coil taping is possible with this pickup/preamp combination!!
New Features:
• Treble ‘Attack‘ boost via Push-Pull on Volume potentiometer
• ‘Q‘ variable gain on top of the set gain levels
• Neck filter 100Hz to 2.5kHz/ Bridge filter 200Hz to 2.5kHz
• Longer battery life and lower noise level
• Filters Range: Neck: 100hz to 2.5khz; Bridge: 200Hz to 2.5kHz.
• Resonant Peak (Q): +3db standard/ +6db switched (boost accessible via Trim-pot)
• Operating Voltage: 9 to 27 Volts
• Current Draw: +-3.4mAh (@9v)
• without knobs
• Filter boards x2: W: 4,4cm; H: 2,6cm; D: 1,7cm Blend board x1: W:3.2cm; H: 2.2cm; D: 1.3cm
• Potentiometers: Hole size is 6.4 mm and bush height is 10mm. (to be used with 6.35mm/6.4mm knobs)
Instructions Manual
