Lusithand Single NFP Special
The NFP-Special preamp is designed specifically for Multicoil pickups that benefit from a “one humbucker per string” type of wiring.
This method of electronically mixing the coils brings maximum output, clarity and punch out of the pickups without any adverse loading effects. The pickup then goes through the tonal enhancer part of the circuit, the NFP, where the filter preamp works its magic.
The Sweepable frequency has a resonant peak that ranges between 150hz and 4 khz which can be boosted by pulling-up on the potentiometer.
The NFP-Special can run from 9 to 27 volts and it has a current draw of +- 2.5 mAh. It provides 6x inputs so that you can wire any multicoil pickup up to 6 strings.
!!No active/passive switching or coil taping is possible with this pickups/preamp combination!!
• 1x Single NFP-Special filter board
• 1x Master Volume potentiometer
• Filters Range: 150 Hz to 4 kHz
• Current Draw: 2.5mAh
• Operating Voltage: 9 to 27 Volts
• without knobs
• Board: W: 4.3cm; H: 2.5cm; D: 1.8cm
• Potentiometers: Hole size is 6.35mm and bush height is 10mm (to be used with 6.35mm knobs)
All our preamps are solderless!
Instructions Manual
